Precast Dominator
This system can be hand set or used as a precast gang form for rapid setting and stripping without the need of additional hardware.

Taper Tie
The taper tie system aids in cost reduction as they can be reused.

This system can be quickly hand set or gang formed for rapid setting and stripping without the need to add additional hardware.
The system can be gang or handset much like any many other forming systems, therefore it is the best of both worlds in a single form. This form is 2 1/2″ thick rather than a standard aluminum form at 2 1/8″ thick, adding to the overall strength of the form. The load point is 2 1/2″ from the face rather than the typical 13/16″ on the standard flat tie system.



Tighter form joints
The Dominator’s design creates tighter joints preventing concrete from leaking between the forms which keeps the forms cleaner and reduces labor time.
Additional Advantages

Create Flatter Walls
The Dominator receives very few hits with a hammer because the form locking device is separate from the form itself. The locking device is located at the back of the side rail. The load point of the tie system has been moved as far from the load as possible; 2 1/2” on the dominator as compared to a standard flat tie form of 13/16”. This creates less vertical deflection, metal fatigue, and flatter walls.

Taper Ties
The Dominator utilizes a Taper Tie System to provide greater form support creating flat, straight walls for concrete homes, commercial projects, retaining walls, precast, or any number of various project designs. The Taper Tie requires fewer ties per joint and is reusable thus reducing long term wall tie costs.

Plug Mold
The holes that remain from the Taper Ties are sealed using tapered plugs. The plugs can be molded with excess concrete on site creating minimal color variation in the wall or they can be created in advance to save time. The tapered plug is coated with a water proof adhesive and placed in the holes of the wall to create a water tight seal.